Installation Sheet

WALL
JAMB
NYLON
SPACER
#8 x 2” TRUSS
HEAD SCREW
HEADER
WALL
JAMB
#8 x 2” TRUSS
HEAD SCREW
HEADER
ANTI-JUMP
Replace one wall jamb [B] and attach to the wall
with a #8 x 2” truss head screw [D] inserted
through the center hole. Slip a nylon spacer [E]
over a #8 x 2” truss head screw and install in
the top hole of the wall jamb. Repeat for the
bottom jamb. Check jamb for plumb and tighten
screws.
NOTE: Do not overtighten the jamb screws.
If not already present, slide the anti-jump
inserts into the center of the header.
NOTE: Header shown
cut away for clarity.
Measure the wall-to-wall opening at the top of the wall
jambs [B] and cut the header [F] 1/16” short of this
dimension. Check the header for fit.
Step 4
Step 5
Step 6
This bath enclosure is equipped with safety
tee-lock wall jambs. When installed properly, the
header is permanently locked to the wall jambs
and cannot be accidentally dislodged.
Slide the safety tee-lock of the unmounted wall
jamb into the header.
Holding the header at an angle, engage the end
onto the mounted wall jamb. Pivot the header
into place, then slide the loose wall jamb to the
wall and press into position on the tub track.
Attach to the wall per instructions in Step 4.
PAGE 5