Installation Sheet
Page 8
Cered 01/04/2017
QCI-5305 Rev 0
HORIZONTAL U-CHANNEL
Find the U-Channel (M). First, the channel needs to be cut to length. Determine the
width of your unit’s Fixed Panel (D) and cut the U-Channel (M) 2-1/2” shorter than
the width of the glass.
Example: 18” Panel width - 2.5” = 15.5” Channel length
Drill two 3/16” holes approximately 3” from the ends.
Posion the U-Channel (M) on the marked centerline of your threshold and slide it
against the side wall. Mark each hole posion on the threshold.
Remove the U-Channel (M) and drill 3/16” diameter holes approximately 1-1/2” deep
at the marked locaons.
Insert a small amount of silicon into each drilled hole, then insert a Wall Plug (K) into
each hole. Carefully cut the heads o each wall plug with a razor blade and posion
the U-Channel (M). You must secure U-Channel before the silicone starts to cure.
Secure the U-Channel (M) with the Screws (L), do not over-ghten.
1
VERTICAL U-CHANNEL
Find the U-Channel (A). To cut the channel, determine the height of your unit and cut
the U-Channel (A) 1-1/2” shorter than the unit height.
Example: 76” unit height - 1.5” = 74.5” channel length
Drill two holes approximately 6” from the top and boom of the U-Channel (A) and a
third hole in the middle.
Hold or tape the U-Channel (A) against the wall and follow instrucon for horizontal
U-Channel (M) to secure to wall.
2