Installation Sheet

Page 9
Cered 01/04/2017
QCI-5305 Rev 0
BOTTOM HINGE
Find the Boom Hinge (J) and place it on the threshold against the horizontal
U-Channel (M). Make sure that the opening for the hinge matches the U-Channel (M)
as shown below. Mark holes on the threshold then remove the Boom Hinge (J) and
drill 3/16” diameter holes approximately 1-1/2” deep (same as U-Channel (M & A)
holes in steps 1 & 2).
Follow the same steps as securing the U-Channel (M & A) to secure the Boom Hinge
(J) to the threshold.
3
Side View
Ensure hinge is in line with
U-Channel as shown
View from outside shower