Installation Sheet

Page
Cered 01/04/2017
QCI-5305 Rev 0
GLAZING GASKET
Spray soapy water on the glass near the U-Channel (M). Then insert the Glazing
Gasket (O) as shown in the gure below. Start at the wall and push the glazing into
the gap unl you reach the Boom Hinge (J) and cut o any extra. Insert one side
completely rst, and then the other.
When inserng the wall Glazing Gasket (B), start from the boom and work your way
up, any extra glazing scking out of the top can be cut o with scissors. Taping the
glazing to the top is helpful for holding it upright while inserng. Using a block of
wood may be helpful for inserng the glazing.
5
TOP HINGE
Find the Top Hinge (E) and loosen the Panel
Clamp Screws (CC). Use an alcohol swab (or
rubbing alcohol) to clean the glass where the
hinge will sit. Place the Clear Vinyl (BB) in the
hinge channel like the boom hinge.
Place the Top Hinge (E) on the notches in the
top of the Fixed Panel Glass (D) and ghten
the Panel Clamp Screws (CC).
6