Installation Sheet

QCI-5307 Rev 0 Page 6 Cered 01/05/17

1 Determine location of the unit centerline on the

threshold. From unit centerline mark location of panel

centerline 1” towards outside of shower. Next, mark a

continuous panel centerline on the wall the panel will

mount to, starting where the threshold centerline meets

the wall. Use a level to ensure the wall centerline is

plumb and straight. The wall centerline should be a mini-

mum of the unit height from the threshold.

NOTE: The unit centerline for this unit does NOT get

anything mounted to it. The Panel and Guide center-

lines are 1” from the unit centerline.

This unit requires a minimum 3” of flat curb to be in-

stalled correctly.

2 Cut the threshold U-channel to the appropriate size. This piece of U-channel will be

equal to the opening width. Next drill three 3/16” diameter holes in the center of U-

channel (centerline groove provided for convenience), two holes approximately 6” from

each end and one in the middle. Place the U-channel in its correct position with the u-

channel centerline over the threshold centerline as marked in step one.

With a pencil carefully mark each hole position on the threshold centerline. Remove the

u-channel and drill a 3/16” diameter hole, approximately 1” deep, directly on the thresh-

old centerline at the marked

locations.

Note: It is critical that the

threshold U-Channel is

centered on the PANEL

centerline.

3” Minimum Curb

1 1/2”

Panel Centerline

Unit Centerline

1”