Installation Sheet
QCI-5307 Rev 0 Page 16 Cered 01/05/17
Door-to-
Door-to-Panel Vinyl
Door-to-Wall Vinyl
25 Place the Door-to-Wall Vinyl on the handle side of
the Door Panel so that the vinyl edge sticks out towards
the inside of the shower.
Optionally, place the Door-to-Panel Vinyl on Door Panel
so that the vinyl edge sticks out towards the Fixed Glass
Panel. Trim the vinyl to fit around the header as shown
at right.
Use silicone to hold in place.
26 On the interior face of the glass, place
a strip of low tack tape on the glass about 1/8”
to 3/16” away from edge of the u-channel both
vertically and horizontally. Run a small bead of
silicone along this edge. Next, on the interior,
run a bead of silicone between the u-channel
and the threshold and also between the u-
channel and the wall. After completing, remove
the tape before silicone sets.
Repeat silicone application process to outside
of door. Apply between fixed glass panel and u
-channel, u-channel and wall, u-channel and
threshold.
NOTE: DO NOT USE the shower until the silicone is completely cured. Check the tube
of silicone for the manufacturer recommended cure time (typically 24 - 48 hours).