Installation Sheet
QCI-5307 Rev 0 Page 14 Cered 01/05/17
20 Using a small Allen Wrench in the adjuster holes around the perimeter of the Roller, adjust the
door panel to match the Fixed Panel height and create an even gap at the wall.
Tighten the Roller Mount when adjustment is complete.
21 Adjust the Anti-Jump has an offset mount to allow for adjustment. Adjust the Anti-Jump so that
it is installed with a 1/16” or less between the itself and the header bar. Tighten the mounting screw
when adjustment is complete.
22 Disassemble the Pull Handle and install on the Door Panel. The Handle should be on the
outside of shower and the Knob on the inside. Install the Knob through the bottom hole..