Installation Sheet

QCI-5307 Rev 0 Page 13 Cered 01/05/17
18 Carefully loosen the Roller Mounts to allow the Door Panel to move to its lowest setting. Lower-
ing the door allows for the next step.
17 Disassemble two Roller Assemblies and loosely secure to
Door Panel Glass.
The Rollers have an offset mount to allow for adjustment. While
mounted onto the Door Panel, rotate the rollers to their lowest po-
sition so that the Door Panel does not hit the ground or U-Channel
during installation. Tighten the Roller Mount
Then carefully lift the door panel into place so the rollers rest on
top of the roller bar assembly.
19 Disassemble the Anti-Jump and install
it below the roller bar assembly in the two
holes provided to hold it in place. Leave the
Anti-Jump Assemblies loose for future ad-
justment.
Roller
Roller
Mount
Anti-Jump
Assembly
Header Bar
Roller