Installation Sheet
QCI-5307 Rev 0 Page 10 Cered 01/05/17
10 Mark the center of the Header Mount Bracket. Drill a 3/16” diameter hole thru the finished
wall material at the marked wall location. Drill a 1/8” diameter pilot hole approximately 2” deep into
the blocking behind the finish wall material.
DO NOT DRILL 3/16” HOLE INTO BLOCKING
Remove the Header Mount Header Bracket by loosening the set screws.
Next, screw the Header Mount Bracket Insert onto the wall with the supplied #10 x 3” Flat Head
screw. Install the Header Bracket Insert with the adjustment slot in the vertical direction. This will
allow for a small amount of adjustment to make sure the header is level.
Snug, but DO NOT completely tighten the NEW Flat Head Screw at this point.
HEADER MOUNT BRACKET
INSERT
SET SCREWS
HEADER MOUNT
BRACKET
REMOVE AND DISCARD THE
INCLUDED WALL PLUG AND
2” FLAT HEAD SCREW
WALL MOUNT HEADER
BRACKET INSERT
#10 x 3” Flat Head Screw
9 Reinstall the Panel Mount Caps. Level the header.
Adjust the Fixed Panel by moving it towards or away from the wall so that the Header Mount Brack-
et touches the wall.
With the Header Assembly mounted, use a pencil to mark around where it sits flush against the door
side wall as shown.
Remove the Header Assembly from the Fixed Panel.
Mark Wall Here
ADJUST WIDTH