Installation Sheet

a.
b.
c.
Close door to make horizontal cent e line
of strike.
r
Measure one half of door thickness from
door stop and mark vertical centre line
of strike.
Drill 1"(25 mm) hole 1/2"(13 mm) deep at
intersection of horizontal and vertical line
of strike.
Match screw holes on strike with centre
lines on jamb.
Mark outline and chisel 1/16" (1.6 mm)
deep for strike.
Install strike and tighten screws.
Ø2-1/8" 54 mm ( )
FOR BACKSET ( )2-3/4" 70 mm
FOR BACKSET ( )2-3/8" 60 mm
45 mm
40 mm
35 mm
1-3/4" 1-3/8"1-9/16"
Make 1"(25.4 mm)hole at center of door edge.
Fold on dotted line and fit on door edge
TEMPLATE
3. INSTALL LATCH
Insert latch in hole and keep it parallel
to door face.
Mark outline of face plate and remove latch.
Chisel 1/8" (3 mm) deep or until
face plate flush with door edge.
Insert latch and tighten screws.
4. INSTALL OUTSIDE KNOB
6. INSTALL STRIKE
a.
b.
c.
Install inside knob and tighten screws until lock is firm.
Insert spindle through latch.
Press flush against door.
NOTE: Key hole must be in down position.
5. INSTALL INSIDE KNOB
Customer service 1-800-221-3379