Installation Sheet

DeadboltLockInstallation

Step1AdjustLatchBackset

AdjusttheBacksettomatchyourdoorbytwisting

theLatchFace1/8turnclockwisefromthetailand

pullingouttochangefrom2‐3/8”to2‐3/4”Backset

orpushingintochangefrom2‐3/4”to2‐3/8”

Backset

RotatetheFacebacktotheLockedPositionbefore

installing

theLatch

Step2InstallLatchintothedoor

InstallLatchintheuppositionasmarkedonthelatch.

CrossshapedcrankshouldbeonthebottomandcenteredL/RinyourLockhole.

Important:Donothammeronthelatch

Step3SingleCylinderLocks

Step3DoubleCylinder



Locks

A) Note:BarSpindleontheBackofthelockshouldpassthroughthecrossshapedcrankoftheLatchintheverticalposition.

B) KeySlotshouldbeatthebottomofthelocksothattheteethofthekeywillfaceupwheninserted.

C) Insertthespindleoftheexteriorlock

bodythroughthelatchandholdthelockcenteredontheborehole.

D) SlidetheturnpieceoftheinteriorassemblyontotheSpindlethatprotrudesthroughthelatch

E) InsertScrewsthroughtheinteriorPlate,thelatchandintotheexteriorBody.

F) Somewigglingmightbenecessarytogetthealignmentright

.

G) CenterLockandtestoperationbeforefinaltighteningofthescrews.

H) InstalltheStrikeontheJamb

A) ExteriorforkedbarSpindleshouldpassthroughthecrossshapedcrankoftheLatchintheverticalposition.

B) InteriorforkedbarSpindleshouldpassthroughthecrossshapedcrankoftheLatchinthehorizontalpositionlockinginto

theexteriorspindle

C) InsertScrewsthroughtheinteriorbody,thelatchandintothe

exteriorBody.

D) Wigglingwillbenecessarytogetthealignmentright.

PAGE 1
Deadbolt Lock Installation Step 1 Adjust Latch Backset Adjust the Backset to match your door by twisting the Latch Face 1/8 turn clockwise from the tail and pulling out to change from 2‐3/8” to 2‐3/4” Backset or pushing in to change from 2‐3/4” to 2‐3/8” Backset Rotate the Face back to the Locked Position before installing the Latch Step 2 Install Latch into the door Install Latch in the up position as marked on the latch. Cross shaped crank should be on the bottom and centered L/R in your Lock hole.
PAGE 2
Door Lock Instructions New Door Preparation Step 3 : Mortise Door for Latch Step 1 : Mark Door A) Fold Template below on Fold Line and Mark Door for Lock Bore Hole at 2‐3/4” or 2‐3/8” Backset and lock Edge Hole Centered on the door edge. A B) For set of 2 Locks, Deadbolt should be 5.