Installation Sheet

5 9
10
11
6
7
8
Install Strike
Adjust Thumb Turn Piece
Install Receiver Module
Insert Batteries
Install Keypad Assembly
Install Inside Mounting Plate
Identify Door Handing
To identify the centre of strike: close
the door to lay the latchbolt against
the door frame.
Mark the centre line on the doorframe
exactly opposite the latch hole in the
door edge.
Install cylinder into the deadbolt
keypad assembly with tailpiece in
horizontal position inserted through
hub of the latch.
the mounting plate.
Fix the mounting plate with screws.
If outside lock assembly is lopsided,
please loosen the screws to adjust its
position and tighten the screws again.
Pass the IC wire through the wire hole of
Face the door from the outside.
The door is left-handed if the hinges are on the left side of the door,
whereas the door is right-handed if the hinges are on the right side of the door.
the interior side of the door, and
insert the tailpiece through the
cross-shaped crank of the latch
Pass the IC wire under the latch to
.
Install the strike plate into your door
frame and tighten with wood screws.
c
Mounting Plate
Screws
b
from door stop and vertically mark
centre line of strike.
Drill 1" (25.4 mm) hole, 1" (25.4 mm)
deep at intersection of horizontal and
vertical line of strike.
Chisel 5/64" (2 mm) deep along the
strike outline to allow the strike to be
aligned with the doorframe.
Measure one half of door thickness
Rotate the thumb turn piece to the LEFT
at 45 degrees for right-handed doors.
Rotate the thumb turn piece to the RIGHT
at 45 degrees for left-handed doors.
Remove the battery cover
(push it up first then pull it out).
a
Screws
Wood Screw
Connect the IC wire into the back of
the receiver module.
Ensure that the deadbolt tailpiece is
engaged with turn piece, then attach
receiver module to the door with
screw.
Use the optional wood screw to
secure the receiver module to wood
doors only.
Insert 4 (AA) 1.5 V alkaline batteries and slide the battery cover back onto the
receiver module.
Remarks:
(1) Alkaline batteries are recommended in order
to stabilize the power supply.
If you don't use alkaline, battery performance
will be reduced greatly.
(2) All settings will be retained in the memory
even if the batteries are completed dead.
TEMPLATE
45mm 40mm 35mm
1-3/4" 1-9/16" 1-3/8"
Fit here on door edge
FOR BACKSET 70 mm)2-3/4" (
FOR BACKSET 60 mm)2-3/8" (
Mark Ø 1" (25.4 mm) hole at
centre of door edge.
Ø ( )2-1/8" 54 mm
For right-handed
door
For left-handed
door

Cylinder
IC wire
Left-handed
Right-handed
Hinge Hinge

Battery Cover
a
Note : The thumb turn piece is opposite
to the latching side.