Installation Sheet
1120
Carefully tuck all wiring into the outlet box . Align the fixture pan over the outletbox , position the
mounting screws through the large openings of the key hole slots . Rotate the fixture pan to seat
the screws, and tighten securely.
Recoja cuidadosamente todo el cableado en el cajetín de toma de corriente. Presente el soporte de la
lámpara sobre el cajetín de toma de corriente haciendo coincidir los orificios de los taladros con las
ranuras grandes. Gire la carcasa de la lámpara hasta poder introducir los tornillos y apriete estos
firmemente.
4.
5. Slide the switch and select the color desired.
Deslice el interruptor y seleccione el color deseado.
Secure the fixture shade and the frame to the fixture pan using the thumb nuts.
Fije la pantalla y el marco de la lámpara al soporte mediante las tuercas de apriete manual.
6.
4
5
6
2.
Connect the black supply wire to the black fixture wire using a wire connector. Connect the white
supply wire to the white fixture wire using a wire connector . Connect the fixture ground wire to the
supply ground wire using a wire connector.
Conecte el cable de alimentación negro al cable negro de la lámpara por medio de una clema. Conecte
el cable de alimentación blanco al cable blanco de la lámpara por medio de una clema. Conecte el
cable de tierra de la lámpara al cable de tierra de la instalación eléctrica por medio de una clema.
3.
2
Thread the mounting screws into the outlet box so that they extend approximately 1/2 in.
below the ceiling.
Enrosque estos tornillos en el cajetín de toma de corriente solo hasta que sobresalgan unos 13mm
(aprox. 1/2 pulgada) del techo.
3
1. Carefully unpack the fixture; lay out all parts on a clean surface.
Desembale cuidadosamente la lámpara y coloque todas las piezas sobre una superficie limpia.