Deadbolt Installation Sheet

ManualsBrandsMiseno ManualsDoor HardwareMiseno Bratton Single Cylinder Keyed Entry Deadbolt and Knobset Combo Pack

Pre-Installation —

Tools Required/Hardware Included

WARNING

If the door needs to be drilled, be familiar with how to use your drill safely, and

understand all the door preparation steps before proceeding.

NOTE

your door. Periodically clean the locks with mild soap and a soft cloth. Do not use abrasives or

harsh chemicals, and avoid sharp or scratching objects.

Read the precautions and instructions in this manual before installing and using this lock.

Save this manual for future reference.

NOTE: To assure proper lockset function, the holes in the door

jamb must be drilled 1-1/8 in. (28 mm) deep.

Using the template, mark the door and drill the holes, and chisel out a mortise.

NOTE: Drill from both sides to avoid wood splitting.

Prepare the door jamb – using the strike plate as a pattern, drill the latch and screw

KROHVDQGFKLVHORXWDPRUWLVHXQWLOWKHVWULNHSODWHğWVĠXVK

NOTE: If your door already has holes, skip to Installation.

D00-A00XP14 Rev. 16/11-01

USE AND CARE GUIDE

FOR

Safety Information

CAUTION

Before beginning the installation, please read and understand the entire manual.

Pre-Installation (continued) — Door Preparation

OptionalOptionalOptionalOptionalOptional

A Key

B Exterior assembly

C Deadbolt Latch

D Interior assembly

E Faceplate

F Strike Plate

Part

Description Quantity

AA Mounting Screws

Latch/Strike Plate Screws

Part

Description

Quantity

Note: Not to scale.

AA BB

2 3/8 in.

(60 mm)

3 7/16 in. (87 mm)

1 1/2 in.

(38 mm)

1 in.

(25 mm)

2 3/4 in.

(70 mm)

3 13/16 in. (97 mm)

1 1/2 in.

(38 mm)

1 in.

(25 mm)

Summary of content (2 pages)

PAGE 1
D00-A00XP14 Rev. 16/11-01 Part USE AND CARE GUIDE Description Quantity A Key 2 B Exterior assembly 1 C Deadbolt Latch D E Interior assembly Faceplate 1 1 F Strike Plate 1 1 FOR OR A B C OR OR D OR E OR AA BB F 1 OR Safety Information Read the precautions and instructions in this manual before installing and using this lock. Save this manual for future reference.
PAGE 2
TEMPLATE ø 2-1/8’’ (54 mm) Fold here. Place on the door edge. Drill a 1” (25 mm) diameter hole at the center of the door edge. NOTE: Double check your product for the correct hole sizes. 1-3/4” (45 mm) 4 1-9/16” (40 mm) ø 1-1/2’’ (38 mm) Backset 2-3/8” (60 mm) Backset 2-3/4” (70 mm) 1-3/8” (35 mm) Installation INSTALLING THE LATCH OR A. Attach the correct faceplate OR OR OR B. Set the latch backset C.