Handle Set Installation Sheet

ManualsBrandsMiseno ManualsDoor HardwareMiseno Bernard Single Cylinder Keyed Entry Deadbolt and Knobset Combo Pack

FOR EXPOSED SCREWS

FOR CONCEALED SCREWS

Pre-Installation —

Tools Required/Hardware Included

WARNING

If the door needs to be drilled, be familiar with how to use your drill safely, and

understand all the door preparation steps before proceeding.

NOTE

your door. Periodically clean the locks with mild soap and a soft cloth. Do not use abrasives or

harsh chemicals, and avoid sharp or scratching objects.

Read the precautions and instructions in this manual before installing and using this lock.

Save this manual for future reference.

NOTE: To assure proper lockset function, the holes in the door

jamb must be drilled 1/2 in. (13 mm) deep.

Prepare the door jamb – using the strike plate as a pattern, drill the latch and screw holes,

DQGFKLVHORXWDPRUWLVHXQWLOWKHVWULNHSODWHğWVĠXVK

Using the template, mark the door and drill the holes, and chisel out a mortise.

NOTE: Drill from both sides to avoid wood splitting.

AA Mounting Screws

BB Latch/Strike Plate Screws

Part

Description

Quantity

AA BB

A Key

B Exterior assembly

C Latch

D Interior assembly

For concealed screws only

D1 Lever

D2 Rose

D3 Mounting plate

E Faceplate

F Strike Plate

Part

Description Quantity

Note: Not to scale.

NOTE: If your door already has holes, skip to Installation.

Optional

L00-000SBR14 Rev. 16/08-04

USE AND CARE GUIDE

FOR

Safety Information

CAUTION

Before beginning the installation, please read and understand the entire manual.

Pre-Installation (continued) — Door Preparation

Summary of content (2 pages)

PAGE 1
L00-000SBR14 Rev. 16/08-04 Part Description Quantity A Key 2 B Exterior assembly 1 C Latch D Interior assembly 1 1 For concealed screws only USE AND CARE GUIDE 1 FOR D1 Lever 1 D2 Rose 1 D3 Mounting plate E Faceplate 1 1 F Strike Plate 1 FOR EXPOSED SCREWS D C B A 2 E F Safety Information OR FOR CONCEALED SCREWS Read the precautions and instructions in this manual before installing and using this lock. Save this manual for future reference.
PAGE 2
TEMPLATE Drill a 1” (25 mm) diameter hole at the center of the door edge. Fold here. Place on the door edge. Ø 2-1/8” (54 mm) NOTE: Double check your product for the correct hole sizes. 5 2” (51 mm) Backset 2-3/8” (60 mm) Backset 2-3/4” (70 mm) 1-3/4” 1-9/16” 1-3/8” (45 mm) (40 mm) (35 mm) Installation INSTALLING THE LATCH OR OR OR A. Attach the correct faceplate B. Set the latch backset Right CAUTION: Be sure the latch cam is upright before making any backset adjustment.