Deadbolt Installation Sheet

AA Mounting Screws

Latch/Strike Plate Screws

Deadbolt Strike Plate Screws

Part

Description

Quantity

Note: Not to scale.

Pre-Installation —

Tools Required/Hardware Included

WARNING

If the door needs to be drilled, be familiar with how to use your drill safely, and

understand all the door preparation steps before proceeding.

NOTE

your door. Periodically clean the locks with mild soap and a soft cloth. Do not use abrasives or

harsh chemicals, and avoid sharp or scratching objects.

Read the precautions and instructions in this manual before installing and using this lock.

Save this manual for future reference.

NOTE: To assure proper lockset function, the holes in the door

jamb must be drilled 1-1/8 in. (28 mm) deep.

Prepare the door jamb – using the strike plate as a pattern, drill the latch and screw

KROHVDQGFKLVHORXWDPRUWLVHXQWLOWKHVWULNHSODWHğWVĠXVK

8VLQJWKHWHPSODWHPDUNWKHGRRUDQGGULOOWKHKROHVDQGFKLVHORXWDPRUWLVH

NOTE: Drill from both sides to avoid wood splitting.

A Key

B Exterior assembly

C Deadbolt Latch

D Interior assembly

E Faceplate

F Strike Plate

G Reinforcement Plate

H Interior reinforcing plate

Part

Description Quantity

NOTE: If your door already has holes, skip to Installation.

D00-000XP14 Rev. 17/11_02

USE AND CARE GUIDE

FOR

Safety Information

CAUTION

Before beginning the installation, please read and understand the entire manual.

Pre-Installation (continued) — Door Preparation

OptionalOptionalOptionalOptionalOptional

PAGE 1
D00-000XP14 Rev. 17/11_02 Part USE AND CARE GUIDE FOR Description Quantity A Key 2 B Exterior assembly 1 C Deadbolt Latch D E Interior assembly Faceplate 1 1 F Strike Plate 1 G Reinforcement Plate 1 H Interior reinforcing plate 1 1 OR A B OR C 1 Safety Information CC BB D OR Read the precautions and instructions in this manual before installing and using this lock. Save this manual for future reference.
PAGE 2
TEMPLATE Fold here. Place on the door edge. Drill a 1” (25 mm) diameter hole at the center of the door edge. 2” (51 mm) Ø 2-1/8” (54 mm) 1-9/16” (40 mm) NOTE: Double check your product for the correct hole sizes. 1-3/4” (45 mm) 1-3/8” (35 mm) For thicker doors: 1-9/16” (40 mm) ~ 2” (51mm) 4 Backset 2-3/8” (60 mm) Backset 2-3/4” (70 mm) Installation INSTALLING THE LATCH OR OR OR A. Attach the correct faceplate OR B. Set the latch backset C.