Installation Sheet

Page | 7
INSTALLATION
This unit is intended to be installed in a ceiling. The joists where the fan is to be installed must be a minimum of 2” x 4”
material to ensure adequate support. The joists should be spaced 12” on center or up to a maximum of 24” on center.
This product is designed for installation in ceilings with a minimum of 9” clearance. Consult with a certified contractor if
you are unsure if the framing / joists in your ceiling are sufficient for these requirements.
Installation Options
The spacing between the joists in your ceiling will determine the installation setup. Measure the distance between the
center of each joist where the unit is to be installed as shown.
12” Joist Spacing
If the joist spacing is 12 inches the suspension bracket is not needed. Secure the fan housing to the joists by its flange
with four (4) ST4x30 screws provided as shown in Figure 1.