Installation Sheet

ManualsBrandsMiseno ManualsHardware120" Bearing Roller Strap Barn Door Hardware Kit

Barn Door Hardware Installation

For Use with 120

Bearing Strap Hanger Kits

7/32"

1/4"

5/32"

The tools below are NOT included in the package and are needed for installation.

Parts Included:

DH = Door Height

Recommend that you layout

your door and hardware on the

floor first to determine spacing.

Measure twice Mount once

Rail must be level to keep door

from moving by itself!

HBD5050X120_INSTRUCTIONS Customer Service 1-800-221-3379

Mortise Door Guide(x1)

ST4.2x25mm(x2)

Ø6 Anchors (x2)

Non-Mortise Door Guide(x2)

ST4.2x25mm(x4)

Ø6 Anchors (x4)

Anti Jump Disk(x2)

13MM 17MM

1.7inch

3/8"

(4.8”for reference)

M6X25mm (x6)

Rail 60” Long (x2)

Rail Wall Spacer（x9）

Lag Bolt M8 x 90MM (x9)

M8 Washer（x9）

Door Stop(x2)

Door Hanger(x2)

Allen Wrench M2（x1）

Rail Mounting Instructions,Locating the Mounting Position

Allen Wrench M4（x1）

120”

16” 16” 16”16”16” 16”

6” 6”

Summary of content (4 pages)

PAGE 1
Barn Door Hardware Installation For Use with 120" Bearing Strap Hanger Kits Parts Included: Rail Wall Spacer（x9） Rail 60” Long (x2) Mortise Door Guide(x1) ST4.2x25mm(x2) Ø6 Anchors (x2) Anti Jump Disk(x2) M6X25mm (x6) Door Hanger(x2) M8 Washer（x9） Lag Bolt M8 x 90MM (x9) Non-Mortise Door Guide(x2) ST4.2x25mm(x4) Ø6 Anchors (x4) Door Stop(x2) Allen Wrench M2（x1） Allen Wrench M4（x1） The tools below are NOT included in the package and are needed for installation.
PAGE 2
Installing the Rail 16“ 16“ 6” 6” 16“ 16“ 16“ 1.7inch 16“ Installing the Rail 3 2" 7/32" Note: Stops may end up inside end mounts depending on your hanger placement,If so place stops on rail before mounting rail. 13MM All Rail Mounts must be screwed into a solid Wood Header Hanger Mounting Instructions 4 Hanger position from the edge can vary based on your door design. Position Shown is for a flat Surface Door you may have to Adjust to center Hanger onto the vertical styles of your door 1.
PAGE 3
6 Bottom Guide Mounting Instructions The Guide Stabilizes the door by keeping the bottom from Swinging. Kit includes both a Mortise (Grove in the bottom of the door) and a Non-Mortise option. 1.2" 1.2" 1/4" 1/4" This step will require hanging and removing the door to measure and install the Guides 1.
PAGE 4
9 Test your Door Door should Slide smoothly in both Directions Optional Accessories Soft Close Adapter Kit Each kit Contains a left and right Soft Closer that mounts behind the Rail and keeps children from slamming doors.