Installation Guide
X2
3
The “COLD” and “HOT” Endbody Assemblies are clearly marked. Place COLD Endbody
Assembly through the appropriate hole in the counter top. Align Endbody Assembly so the
Rubber Access Plug (1) is facing the rear. Repeat process for the HOT Endbody Assembly.
X2
X2
5
Place Spout Assembly through the center hole of counter top. From below, reinstall the Spout
Rubber Washer (1), Metal Washer (2), and Mounting Nut (3). Loosely assemble at this time.
Reinstall Inlet Hose Assembly (4)
NOTE:
Opening within the Metal
Washer (2) should face
towards the rear.
5/10 6/10