Instructions / Assembly

REFER TO FIG. 1 BELOW.
6. Assemble center axle brace (18) on bed (1) with hex nut (15) and
washer (12). Assemble center front axle brace (18) on front axle
support (3 with hex nut (15), bolt (16) and washer (12).
7. Put the handle (6) to yoke (5) using bolt (11), washer (12) and
hex nut (15).
ASSEMBLY INSTRUCTIONS (CONT.)
FIG 1
Steering
Link
Connector
Step 2
1. Turn the rear axle support (4) to line up with the holes on the bed (1)
and lock it in place with hex nut (15) and washer (12).
2. Assemble center front axle brace (18) on bed (1) and axle on rear
axle support 4), use hex nut (15) and washer (12) and then tighten.
3. Slide the wheel (7) onto the rear axle support (4), with the valve stem
facing out. Use washer (14), and lock nut (17) to fasten the wheel (7).
FIG. 2
ASSEMBLY INSTRUCTIONS (CONT.)