Instructions / Assembly

Before assembly, check and make sure all parts and hardware

mentioned in this manual are included in this package.

NOTE: Do not completely tighten the screws until the assembly is

complete. For easier assembly, we recommend two people to assemble

this project. Unpack and lay out all components. Use the shipping carton

STEP 1

1. Turn the cart bed (1) upside down on the shipping carton.

2. Turn the front axle support (3) to line up with the holes on the bed (1)

and secure it to the bed with hex nut (15) and washer (12).

3. Assemble the steering link connector (19) on the front axle support

(3) with hex nut (15), bolt (10) and washer (12). Do not fully tighten.

4. Slide the wheel (7) onto the front axle support (3), with the valve

stem facing out and secure it using washer (14), and the lock nut (17),

then fully tighten.

5. Mount the yoke (5) onto the front axle support (3) as shown in Fig 1.

Put the short leg of the yoke (5) onto the center stud of the front axle

support (3). Use lock pin (9) and washer (13) to fasten it. The long

side mounts to the front axle support (3) and steering link connector

with bolt (10), washer (12) and hex nut (15).

ASSEMBLY INSTRUCTIONS

SAFE USE INSTRUCTIONS

● 550 lbs maximum capacity with an evenly distributed load. DO NOT

OVERLOAD THE CART.

● DO NOT

● DO NOT operate if any part is damaged or broken.

● Lower fence rails when loading large items onto cart.

● Distribute load evenly in cart bed.

● DO NOT use on steep inclines where tipping may occur.

● DO NOT allow children to use this cart. IT IS NOT A TOY!

● This cart is designed to carry goods, DO NOT use it as personal

transportation.

● Always block all four wheels when loading or unloading the wagon on

an incline.

● Keep parts and screws out of the reach of children.