Instructions / Assembly

Step 1:
Locate the wagon tray (P), rear axle assembly (T), rear axle supports (U) and mounting hardware (bolts (A), flat washer
(H), lock washer (J) and hex nuts (K).
Step 2:
The washers and nut should be located on the wagon.Tighten nuts and bolts using phillips screwdriver and crescent
wrench.
Step 3:
Slide rear axle supports (U) onto the axles and attach to wagon tray (P) using bolts (A), flat washer (H), lock washer (J)
and hex nuts (K). Tighten nuts and bolts using #2 Phillips screwdriver and 10mm wrench.
Page 3 of 6