Use and Care Manual

FIRE TABLE WON'TLIGHT? IGNITION PROBLEM?

IGNITION TROUBLESHOOTING

STEP 1

STEP 2

Wait 5 minutes for any gas to dissipate. Locate the igniter cable under table. Ensure the

igniter cable is firmly attached to the gas valve. Follow the ignition sequence again. If still

no results after three tries move to step 2 below.

Turn the gas cylinder valve to the "Closed"position. Wait 5 minutes for any gas to dissi-

pate. Ensure igniter cover is not covered by glass rocks. This helps air circulate. Inspect

the ignition electrode (under igniter cover) to ensure it is free from dust and not blocked by

glass rocks or other debris. Use a dry clean cloth or tissue to very lightly wipe clean igniter

tip.

After waiting for 5 minutes, visually inspect the spark by rotating the knob to high without

turning the gas back on at the cylinder. Ensure the spark gap is 3-5mm (1/8"-3/16") from

the burner port and has a clear path. Once you ensure the igniter is operating properly

repeat the ignition sequence in section 2.

WARNING HAZARD:

USE A TOOL OR WEAR GLOVES TO MOVE GLASS ROCKS. AVOID BLOWING GLASS DUST IN THE AIR.

ENSURE IGNITER(UNDER IGNITER

COVER) IS FREE FROM DUST AND

NOT BLOCKED BY GLASS ROCKS

CAUTION: Watch for glass dust

ENSURE IGNITER CABLE

IS FIRMLY ATTACHED