Use and Care Manual

12
WARNING:
Ensure that no parts of your body, clothing, or any other combustible material are
above the burner before, during and after ignition. Ensure the cover is stored safely
away from the Fire Table when the Fire Table is in use.
STEP7
STEP8 PERIODIC INSPECTION OF BURNER FLAMES
Once the unit is burning normally,
set the dial to desired flame height.
Upon igniting the appliance, visually verify that the burner is
indeed burning as demonstrated in the image. The presence of
flames will confirm that the burner is burning. Periodically check
that the burner flame is present during operation by visually.
If there are no flames present, as demonstrated in the image,
the appliance is likely not burning. If this is the case, IMMEDI-
ATELY turn the valve to the "off" position if it is not already and
repeat the ignition procedure as outlined in Section 2.
Normally the burner flame is yellow.
If the burner flame is blue and very small, please check the gas cylinder, as it may
be low gas pressure or empty. If there is enough gas in the cylinder, please contact
customer service to change the burner of the gas fire pit.
If flames lift away from burner or backfire happens, or produce thick black smoke,
the fire pit should be turned off immediately. The fire pit should not be operated
again until the unit is serviced and/or repaired by a qualified service technician.
!
WARNING:
Improper lighting procedure may cause fire
explosion, and result in property damage,
personal injury, or loss of life.
Yellow Tip
Primarily Blue
Flame
!