Use and Care Manual

Before igniting the unit for the first time, follow steps one through 5 in the below

Ignition section.1AAA 1.5V battery is needed

（NOT

included）

WARNING: When the user starts the ignition operation, ensure that the

environment is dry, carefully follow the six steps strictly to ignition operation. The

wrong operation may: 1. prevent ignition operation. 2. cause gas leakage and

explosion.

NOTE TO USER:

SECTION 2: IGNITION

STEP1

STEP4

STEP6

STEP5

STEP2

STEP3

Caution: Always ensure the gas valve orifice and burner tube

venturi is clear of all debris including spider webs.

Your Fire Table is equipped with an auto spark ignition (piezo ignition). Push the knob in

and slowly turn counter-clockwise to the high position. The ignitor will spark and ignite the

gas.

Should the appliance fail to ignite on the first try, promptly repeat the ignition attempt

within 5 seconds. If a third attempt fails to ignite the Fire Table then rotate the knob to the

"off " position and wait 5 minutes before attempting to ignite again.

*** SLOWLY *** turn cylinder valve to the open position to avoid tripping the excess

flow safety device in the gas regulator.

For more information about the excess flow safety device see Section 3 (page 16).

Ensure that unit valve dial is in the "OFF" position by pushing

and turning clockwise until the dial stops.

Ensure the gas hose is not contacting the top of the Fire Table

enclosure and the tank is stabilized in the collar with the wing

nut.

Connect the LP gas cylinder. See section labeled "Connection" .

Leak Test all connections. See section labeled "Leak Test".