Installation Guide

Step
countertop
3: Install faucet and mounting hardware
Insert faucet body (2) into
hole in countertop or deck
plate assembly (3). Install
mounting hardware (4A, B
& C) from underneath the
4A
4B
4C
3
Step 5: Attach spray hose and counterweight
Connect spray hose (5)
to quick connector (7)
attached to supply line.
Install weight (6) on lowest
vertical point on spray
hose (5)
7
5
6
Step 4: Secure mounting hardware
Adjust direction of faucet
body (2) so that handle is on
right side of faucet. Tighten
mounting nut (4B) until snug.
Tighten mounting screws
(4C) to nut with Phillips
screwdriver until snug
4C
4B
Connect waterlines (not
included) to hot and cold
copper lines (8). Connect
waterlines (13) to angle
stops. Tighten both ends of
waterlines with a wrench
until snug. Turn on hot and
cold angle stops and check
for leaks
Step 7: Flush spray hose
Step 8: Check for leaks
Remove spray head (1) from
spray hose (5). Hold tip of
spray hose (5). Turn faucet on
and let the water run for 60
seconds to ush any debris
Check for leaks at the
connections. Retighten if
Step 6: Connect waterlines
necessary
NOTE: Please make sure
washer (12) is installed
attaching spray head to hose
5
1