Installation Guide

Table Of Contents

Prior to Installation:

•

Make sure you have all necessary parts by checking the diagram and parts

list.

Turn oﬀ the cold and hot water at the angle stops and turn on the old

faucet to rele

ase any built up pressure

Flush angle stops to release any deb

ris prior to installation

Pre-drilled hole size requirement: 1-3/8” (min) – 1-1/2” (max)

Max countertop thickness: 1-3/8

1, 2, or 3 hole installation

Single Handle Pull-Down Kitchen Faucet

Installation Manual

•

For single-hole installation:

Deck plate (3A), base plate

(3B), and silicone sealant

are NOT required

Step 2B: Faucet installation - without deck plate

Step 1: Remove mounting hardware

Remove the mounting

screws (4C), mounting nut

(4B), and rubber & metal

washer (4A) from the

mounting pipe

Step 2A: Faucet installation - with deck plate

For three-hole installation:

Deck plate (3A), base plate

(3B), and silicone sealant

(optional) are required

PAGE 1
Step 1: Remove mounting hardware Remove the mounting screws (4C), mounting nut (4B), and rubber & metal washer (4A) from the mounting pipe Single Handle Pull-Down Kitchen Faucet Installation Manual Prior to Installation: 4A 4B 4C • • Make sure you have all necessary parts by checking the diagram and parts list.
PAGE 2
Step 3: Install faucet and mounting hardware Insert faucet body (2) into hole in countertop or deck plate assembly (3). Install mounting hardware (4A, B & C) from underneath the countertop Step 6: Connect waterlines Connect waterlines (not included) to hot and cold copper lines (8). Connect waterlines (13) to angle stops. Tighten both ends of waterlines with a wrench until snug.