Instruction Manual

Let your frame dry at least 20
minutes. While you wait, clean
your mirror where the frame
will apply using included alcohol
wipes. Allow to dry for five minutes so
the mounting tape will adhere
properly. Do NOT use any cleaning
agents other than rubbing alcohol as
this can compromise adhesion.
INSTALLING THE FRAME
Prepare to test fit the
frame to the mirror.
Locate placement corner
blocks and remove tape backing
from the blocks. (Do not yet
remove tape backing from the
If your clips are too large and prevent frame from fitting flush
to the mirror, replace old clips one by one, with replacement
clips you ordered. Make sure these new clips are securely
anchored to the wall, preferably into wall studs.
While leaving placement
corners on the mirror,
take the frame down and
peel off the frame’s tape
backing.
Without touching the frame
to the mirror, guide the
frame into place using the
placement corner blocks. Push the
frame towards the mirror starting
with the top edge. Firmly run your
hands along the entire surface of the
frame to affix it permanently.
Remove placement corner
blocks and clean any
residue with rubbing
alcohol if necessary. Stand
back and look at your
gorgeous, framed mirror!
Caring for your frame
Simply dust or wipe your frame with a damp cloth. To clean your mirror, spray glass cleaner to a cloth first,
not directly to the mirror. Never apply painter’s tape to your frame.
Le yr makeer? Share it!
Tag @mirrormate on social media Email photos to [e-mail]
Felt pad
faces mirror
If you have a towel bar, light, etc. that prevents you from putting frame straight on, please call us
at 866-304-6283 Monday-Friday from 9-5 EST or go to mirrormate.com/troubleshooting for help.
12
13
When the frame is where you
want it (use a level if you wish),
press the placement corner
blocks to both upper inside frame
corners, as shown. If you were sent a 3rd
corner, place it in the middle. You may
reposition them as needed.
10
frame.) Now lift frame into place. The frame must fully
cover the mirror surface evenly on all sides and lay
flush. If the frame fits and makes full contact with the
mirror, proceed to step 10. If not, see below.