User Guide
3 • Miro Canvas • User Guide
European Conformity
High Voltage
UK Conformity Assessed
Warning or Caution
OPERATING PRECAUTIONS
• Instrument is only to be operated by personnel who have read the User Guide in full and are using proper
personal protective equipment.
• Voltage applied during use. Follow all instructions when loading the instrument.
• Use care when loading the cartridge on the instrument electrode board.
• Handle liquids near the instrument with extreme caution.
• Do not overll reagent reservoirs.
• Use the instrument only within the environmental conditions specied in this document.
• Use only the power supply and cables provided with the instrument.
• Use only the Wi-Fi antenna provided with the instrument.
• Use the instrument in a dry environment, especially if synthetic materials are present (synthetic clothing,
carpets, etc. may cause damaging electrostatic discharges).
• Do not use this instrument in close proximity to sources of strong electromagnetic radiation, as these may
interfere with proper operation.
• Treat all samples as potentially biohazardous in accordance with your organization’s approved procedures.
• Operate the instrument in a clean indoor area free of dust.
• Do not operate the instrument if the internal components have been damaged or exposed to uids.
• Use only unexpired reagents and consumables.
• Store Miro Dropgloss bottle upright and away from light.
• Do not aliquot Miro Dropgloss. Leave in the original container.
• Only write on cartridges with soft permanent or laboratory markers (Sharpie
®
or similar). Do not apply pressure
to the cartridge or cartridge lm/label if annotating with markers.
• Instrument electrode board is vulnerable to scratching. Do not slide the cartridge on the electrode board.
Do not wipe the electrode board with any material.
• Be aware of pinch points when opening and closing the instrument lid.
FCC COMPLIANCE (FCC ID: 2A6E7MIROCANVAS10 CONTAINS FCC ID: VVXLM823)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
CAUTION: Changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
If the device has removable antennas then a list of the antennas that may be used with the device must be
included in the user manual. The list should identify the type of antenna, impedance
(usually 50 ohms), and the maximum gain in dBi.
SYMBOL TABLE