Users Manual

-8-

DOC015145EN-A

BLE 3000 Module User's Guide

General

2.6 Module Management

The Module Management Mode is conﬁgurable using DMCUser software.

When a dosimeter is conﬁgured in "All" mode and has been

equipped with a module, the "Detach Module" command

resets the fault message "Mod def" and return to operate

without any module.

Note that the behavior is the same for battery removal.

Note: This command resets the secondary dose of the dosimeter.

Note: if the dosimeter is conﬁgured in "Neutron required" or "Hp(0,07) required" mode, this command resets the secondary

dose but it does not modify dosimeter operation.

 None: any module connection is ignored by the dosimeter.

 All: DMC 3000 accepts any type of modules. When a module is connected, the dosimeter automatically

changes its display conﬁguration and displays the Hp(10) neutron or Hp(0,07) shallow dose depending on

the type of module.

 Hp(0,07) required / Telemetry required / Neutron required / NTx required / eTx required / Bluetooth

required: DMC 3000 needs the required module otherwise a default message "WRG MOd" is displayed or

"Mod def" if no module is connected.