User's Manual

Final ass
6
4. FINAL ASSEMBLY AND THE FUNCTIONALITY TESTING
THE RF-MODULE INSTALLATION
The RF-module is installed on top of the KRO-board on the HV-convertor’s interference
shield as follows:
1. The interference shield’s surfaces are cleaned with rubbing alcohol to remove any
grease residues.
2. The askew edge of the interference shield is covered with two layers of polyethene
adhesive tape 21220033 as shown in Figure 6.
3. A piece of dual-sided adhesive tape (approx. 16×12 mm
)
is attached on top of the
interference shield as shown in Figure 7. The tape is pressed with fingers to ensure
that the adhesive tape attaches itself properly.
Figure 6. The attaching of the polyethene tape and the dual-sided adhesive tape on
top of the interference shield.
Figure 7. The dual-sided adhesive tape on top of the interference shield.