User's Manual

General
3
2. GENERAL
This document describes the installation of the 915 MHz WRM-radio (XB Pro 900 HP) in
the RDS-32 -meter.
3. RDS-32 METER PREPARATION
RF-MODULE PREPARATION
The preparation is as follows:
NOTE! The antenna is fragile and must not be bent.
The RF-module contacts (1-10) are cut to a length of 2,5 mm as shown in Figure 1.
1. Attach the 2×16 mm piece of dual- sided adhesive tape to the 21220028 RF-module
as shown in Figure 2.
Figure 1. The cutting and trimming of the contacts of the RF-module contacts.