User guide
www.mirion.com
© Copyright 2012. All rights reserved for trademark and registered trademark
information.
Quadtek® is a registered trademark of Mirion Technologies Corporation.
The above specications may vary according to system conguration.
Mirion Technologies Incorporated reserves the right to amend or change the
information on this sheet without prior warning.
01/12
315 Daniel Zenker Drive
204 IST Center
Horseheads, NY 14845
USA
T +1.607.562.4300
+1.800.432.1478
F +1.607.562.4392
2 Columbus Drive
Southwood Business Park
Farnborough, Hampshire
GU14 0NZ, UK
T 01252 375137
F 01252 391890
Kaiser-Konrad-Str 93a
D 53225 Bonn
Deutschland
T 0228.625088
F 0228.626300
12954 Stonecreek Drive
Suite C
Pickerington,OH43147
USA
T +1.614.367.2050
F +1.614.367.2464
RETRACT
Cylinder 50mm (2”) bore with steel rod;
Standard
/AL12-305mm(12”)stroke
Optional:
/AL18-457mm(18”)stroke
/AL24-610mm(24”)stroke
/AL30-767mm(30”)stroke
Air Requirements Minimum 30 psig (207 kPa); maximum
inlet presssure 160 psig (1103 kPa)
Power Specification 100/240VAC,50/60Hz
Ambient Temperature 4°C to 71°C (-40°F to 160°F)
SPECIFICATIONS AND PERFORMANCE
RESERVOIR
Dimensions Clearance envelope;
240mm W x 490mm H x 225mm D
(9.4” x 19.3” x 8.9”mm)
Mechanical 1/2”NPTfemalethreadedinlet,ve
micron lter, check valve at inlet to allow
one-wayairow
Air Hose Aeroquip SH925 (5 meters)
Air Storage Reservoir stores enough air for 1 retrac-
tion of the 762mm (30”) stroke cylinder
@ 276 kPa (40 psi)
CONTROLLER
Operation Modes Automatic retract when air pressure
drops below a set level or if power fails.
Forwatercooledlens:Retractswhen
coolingowdropsbelowasetlevel.
Camera can also be manually retracted
and inserted by the operator.
Min. Air Pressure Set Point Factory preset to 2.5 psig (17 kPa) min.
lens pressure
Min Water Flow Set Point 1 gpm
SAMPLE REPRESENTATION: 12” RETRACT AND
72” RAIL
Top Figure The pneumatic retract is fully inserted
into the process.
Middle Figure The pneumatic retract has retracted
the lens 12 inches (305mm) from the
heat of the process to the end of the
cylinder stroke.
Bottom Figure The lens and camera have been manu-
ally pulled back to the length of the
extended rail.
CONTROLLER
Controller Ambient Temp. 0° to 54°C (32°F to 130°F)
Physical Dimensions 254 W x 305mm H x127mm D
(10” x 12” x 5”)
Enclosure Specifications IP66 (prior to modication) to EN 60
529/10.91
Sheet steel, dipcoat primed and powder
coated in textured RAL 7032