Instruction Manual

315 Daniel Zenker Drive
200 IST Center
Horseheads, NY 14845
USA
T +1.607.562.4369
+1.800.432.1478
F +1.607.562.4392
Station Road
Alton, Hampshire
GU34 2PZ, UK
T 01420.541600
F 01420.541700
19501 144th Ave NE
Suite C400, Woodinville
WA 98072, USA
T [phone]
F [phone]
© Copyright 2009. All rights reserved for trademark and registered trademark
information.
The above specications may vary according to system conguration.
Mirion Technologies Incorporated reserves the right to amend or change the
information on this sheet without prior warning.
03/09
RETRACT
Cylinder 2” (51mm) bore with steel rod;
Standard
/AL12-12”(305mm)stroke
Optiona:
/AL18-18”(457mm)stroke
/AL24-24”(610mm)stroke
/AL30-30”(767mm)stroke
Air Requirements Minimum 30 psig (207 kPa); maximum
inlet presssure 160 psig (1103 kPa)
Power Specification 115/230VAC,50/60Hz
Ambient Temperature -40°F to 160°F (4°C to 71°C)
Retract Rail All aluminum construction;
Standard:
/RL42-42”(1067mm)rail
/RL30-30”(762mm)rail
/RL54-54”(1372mm)rail
/RL66-66”(1676mm)rail
/RL78-78”(1981mm)rail
SPECIFICATIONS AND PERFORMANCE
RESERVOIR
Dimensions Clearance envelope;
16.5”W x 13.65”H x 5”D
(419mm x 347mm x 127mm)
Mechanical 1/2”NPTfemalethreadedinlet,vemi-
cron lter, check valve at inlet to allow
one-way air ow
Air Hose Aeroquip SH925 (5 meters)
Air Storage Reservoir stores enough air for 1
retraction of the 30” (762mm) stroke
cylinder @ 40 psi (276 kPa)
CONTROLLER
Operation Modes Automatic retract when air pressure
drops below a set level or if power fails.
For water cooled lens: Retracts when
cooling ow drops below a set level.
Camera can also be manually retracted
and inserted by the operator.
Min. Air Pressure Set Point Factory preset to 2.5 psig (17 kPa) min.
lens pressure
Min. Water Flow Set Point 1 gpm
SAMPLE REPRESENTATION: 12” RETRACT AND
72” RAIL
Top Figure The pneumatic retract is fully inserted
into the process.
Middle Figure The pneumatic retract has retracted
the lens 12 inches (305mm) from the
heat of the process to the end of the
cylinder stroke.
Bottom Figure The lens and camera have been manu-
ally pulled back to the length of the
extended rail.
CONTROLLER
Controller Ambient Temp. 32°F to 130°F (0° to 54°C)
Physical Dimensions 10”W x 12”H x 5”D
(254mm x 305mm x 127mm)
Enclosure Specifications IP66 (prior to modication) to EN 60
529/10.91
Sheet steel, dipcoat primed and pow-
der coated in textured RAL 7032