Phau Ntawv Qhia
Table Of Contents
- Table of Contents
- List of Figures
- List of Tables
- 1.0 Introduction
- 2.0 Mechanical Installation
- 2.1 Mounting Dimensions
- Table 3 BB-1001 Backbox Dimensions
- Table 4 BB-1002 Backbox Dimensions
- Table 5 BB-1003 Backbox Dimensions
- Table 6 BB-1008 Backbox Dimensions
- Table 7 BB-1012 Backbox Dimensions
- How to mount the BB-1000 Series enclosures directly to the wall
- 1. Open the front door.
- 2. Mount the backbox to the wall using the four screws provided.
- 1. Place the RAX-LCD-LITE into the backbox, ensure that the mounting holes on the annunciator line up with the studs in the backbox.
- 2. Place the Annunciator Cover Bracket over the RAX-LCD-LITE and use the nuts provided with the backbox to secure the assembly. Refer to the figure below.
- 2.1 Mounting Dimensions
- 3.0 Wiring Instructions
- 4.0 DIP Switch Settings
- 5.0 Specifications and Features
- 6.0 Warranty & Warning Information
14
Specifications and Features
5.0 Specifications and Features
5.1 Enclosure Models
The finish of all enclosures is painted semi-gloss off white. For enclosure dimensions see 2.0
Mechanical Installation.
5.2 RAX-LCD-LITE Specifications
• 24 VDC Power Limited Nominal Voltage
• Sealed membrane-like buttons and LED indicators.
• Local Buzzer, Indicators (AC-On, Common Trouble, Remote Failure, Aux. Disconnect,
Acknowledge, General Alarm, Signal Silence, Test/Config Mode), and Controls (System
Reset, Lamp Test, Fire Drill, Aux. Disconnect, Buzzer Silence, Signal Silence, General
Alarm, Acknowledge). Refer to LT-1083 for more button and indicator descriptions.
Table 10 Enclosure Model Descriptions
Model
Number
Material Description
BB-1001 18 GA. (0.048") thick CRS Backbox for one annunciator chassis with keylock door
BB-1002 18 GA. (0.048") thick CRS Backbox for one annunciator chassis with keylock door
BB-1003 18 GA. (0.048") thick CRS
Door is 16 GA (0.060”)
Backbox for one annunciator chassis with keylock door
BB-1008 16 GA. (0.060") thick CRS
Door is 14 GA (0.075”)
Backbox for one annunciator chassis with keylock door
BB-1012 16 GA. (0.060") thick CRS
Door is 14 GA (0.075”)
Backbox for one annunciator chassis with keylock door
Table 11 Button Descriptions
Description
Alarm Queue Button and Indicator
Flashes red when there is an alarm in queue. The buzzer sounds steady.
An alarm can be generated in two ways
• When any Alarm configured point or input activates.
• Pressing the General Alarm button and the system is set for Two Stage operation.
Pressing the Alarm Queue button allows the user to cycle through and review a list of active alarms from
oldest to most recent. Once all alarms in the queue have been reviewed the LED will illuminate steady.
Resetting the panel clears the indication and turns the LED off.
firealarmresources.com