Installation manual

Configuration
54
Command Menu-->Dialer Config
Telephone Line
Note: Refer to How to Use the Keypad to Program the FA-300 on page 39 for detailed instructions on
making menu selections.
Command Menu/Dialer-Config/Telephone
Line
1. Line#1 Dialing Type
[X] DTMF Dial->Def
[ ] Pulse Dial
Set the dialing type for line #1; this is
the type recognized or preferred by
the telephone company.
Command Menu/Dialer-Config/Telephone
Line
2. Line#2 Dialing Type
[X] DTMF Dial->Def
[ ] Pulse Dial
Same as Line#1.
Command Menu/Dialer-Config/Telephone
Line
3. Line#1 wait for Dial tone
[X] ENABLE ->Default
[ ] DISABLE
Use this function to let the system
know whether or not to wait for a dial
tone before dialing. Cell phone setup
for the dialer requires that the system
not wait for dial tone before dialing.
Command Menu/Dialer-Config/Telephone
Line
4.Line#2 wait for Dial tone
[X] ENABLE ->Default
[ ] DISABLE
Same as Line#1.
Command Menu/Dialer-Config/Telephone
Line
5.Number of retries
06 ->Default
Set the number of retries for both
line#1 and line#2. This function lets
the dialer retry on either line if it is
busy or not available. If the retry
count expires, the panel reports a line
trouble.
1 Line1 Dialtype
2 Line2 Dialtype
3 Line1 Dialtone
4 Line2 Dialtone
- Telephone Line -
5 Num of Retries
Line#1 Dialing Type:
[X] DTMF Dial
Line#2 Dialing Type:
[X] DTMF Dial
Line#1 Wait Dialtone
[X] ENABLE
Line#2 Wait Dialtone
[X] ENABLE
Number of Retries:
06