Installation manual

Configuration
52
9. Dialer Config (Command-Menu)
The following illustration shows the dialer configuration menu. Each item in this menu is described below in detail.
Command Menu-->Dialer Config
Account Info
Note: Refer to How to Use the Keypad to Program the FA-300 on page 39 for detailed instructions on
making menu selections.
Command Menu/Dialer Config/Account
Info
1.Account# 1 Identification
123456->Default
Use this function to set the Account
ID for the monitoring station to which
the dialer reports events. The
maximum # of digits allowed is six.
For contact ID, only the first four
digits are used; the last two are
truncated.
Unless you are using the SIA
protocol, the allowed digits for the
account ID are simple digits 0 to 9
and hexadecimal digits A to F (the
SIA protocol only allows digits 0 to 9).
To enter hexadecimal digits, press
the INFO button. The letter “A” will
appear. To scroll through the rest of
the letters, press INFO repeatedly.
Press # to move the cursor to the
right or press * to move it to the left.
1 Account Info
2 Telephone line
3 Report Options
4 Time Parameter
-Dialer Config-
5 Enable/Disable
6 Ring Detect
1 Account#1 ID
2 Account#1 Tel
3 Accnt#1 Format
4 Account#2 ID
- Account Info -
5 Account#2 Tel
6 Accnt#2 Format
Account#1 ID:
_