Installation manual

FA-300 Series LCD Version Installation and Operation Manual
45
Command Menu-->FA-300 Config
Opt Zone Label
Use the keys in described below for entering a message. These letter keys are alternate functions of the numbered
keys are physically located in the same position as described below.
Command Menu-->FA-300 Config
Default Configuration
Note: Refer to How to Use the Keypad to Program the FA-300 on page 39 for detailed instructions on
making menu selections.
Command Menu/FA-300 Config/Opt. Zone
Label
1.Indicating zone label
4.
[NAC-1 ]->Default
[NAC-4 ]->Default
KEYPAD TRANSLATION AS MARKED ON THE KEYS
Sequence refers to the number of times the
key must be pressed to achieve the number or
letter
KEY SEQ 1 2 3 4 KEY SEQ 1 2 3 4
--------------------------------------
Key #1 1
Key #2 2 A B C Key #3 3 D E F
Key #4 4 G H I Key #5 5 J K L
Key #6 6 M N O Key #7 7 P R S
Key #8 8 T U V Key #9 9 W X Y
Key #0 0 Q Z Key * Backspace
Key # Forward
Press the ENTER key to input the message.
Press “UP” and “DOWN” to select
between Y/N. if “ENTER” is pressed the
default configuration is restored.
Use this function to load the default configuration in the
panel.
Warning: By loading default configuration all the previously
programmed configuration is lost permanently.
1 NAC-1
2 NAC-2
3 NAC-3
4 NAC-4
Indicating Zone
NAC-1 Label
NAC-1
NAC-4 Label
NAC-4
Load the default
settings? Y
Default settings
have been loaded