Installation manual

Configuration

Command Menu-->FA-300 Config

Inp Zone

This menu is used to program the process type for the initiating circuits. The maximum number of initiating circuits

supported is 12, but only those supported by the particular model will be shown.

Command Menu-->FA-300 Config

Zone

Note: Refer to How to Use the Keypad to Program the FA-300 on page 39 for detailed instructions on

making menu selections.

Command Menu/FA-300 Config/Ipt. Zone

1. Type (Initiating circuit)

12.

[X] ALARM ->Default

[ ] VERIF ALARM

[ ] SPRKL ALM

[ ] WTR-FLOW ALM

[ ] NON-LATCH SUP

[ ] LATCH SUPV

[ ] GEN ALARM

[ ] MONITOR

[ ] TRB ONLY

Use this function to program

the process type of each input

zone. (See CIRCUIT TYPE

section for details.)

[ ] Zone-1->Default

[ ] Zone-12->Default

Use this function if i

devices

are present on a zone. (See i

devices section for details).

1 Zone-1

2 Zone-2

Initiating Zone

12 Zone12

Zone-1 Type

[X] ALARM

Zone-12 Type

[X] ALARM

[ ] Zone-1

[ ] Zone-2

I3 Detection Zones

[ ] Zone-12