Installation manual

Configuration
36
Configuration
There are three methods of configuring the FA-300 LCD Series Fire Alarm Panels:
Direct configuration using the main LCD display and the menu buttons.
Using a PC or Lap Top Computer with a UIMA converter module.
Using a PC or laptop computer with remote connection (must use fire alarm with built-in UDACT).
The following information for configuring an FA-300 LCD Series Fire Alarm Panel is based on using the front panel
main LCD display for configuration.
To access configuration mode press the Menu button on the front panel display. The LCD will display the Main
Menu. The function of different buttons on the front panel display is shown in Figure 23, below.
Figure 25: FA-300 Configuration
Entering the Passcode
The programming section is passcode protected. The following image shows the message that is displayed to enter
the passcode. The minimum number of digits allowed is four and the maximum allowable passcode is ten digits
long; numerical values only. Press the “ENTER” key after entering the passcode. If the passcode is right, it will take
you to the main command menu. If the passcode is wrong the system will ask you to re-enter the passcode. The
system will be exhausted after three retries and will then take you back to the Normal message display. The default
password is “1111” (without quotes).
SYSTEM
RESET
SIGNAL
SILENCE
FI RE
DRI LL
BUZZER
SILENCE
LAMP
TEST
1
4
7
*
2
5
8
0
3
6
9
#
ENTER
ME N U
CANCEL
INFO
ABC DEF
GHI JKL MNO
PRS
TUV
WXY
QZ
A.C. ON ALARM SUPV TRBL CPU FAIL
SYSTEM NORMAL
18:01 MON 2003-04-05
Enter passcode
_