Installation manual

Mechanical Installation

Installing the Enclosure

Install the FA-300 Series Fire Alarm Panel enclosure as shown below for the twelve zone models. Mount enclosure

surface mount using the four mounting holes, as shown and the screws provided. The backbox may be semi-flush

mounted using the trim ring model FA-UNIV-TRB (BLACK), see Figure 2. Remove the door (also disconnect the

ground strap), the dead front (if supplied) and mount the backbox in between the studs. Place the trim ring around

the backbox. The trim ring is glued in place to the wall surface, after the wall is finished. Replace the front door and

ground strap.

Figure 1: Box dimensions, surface mount

11"

14.5"

1.5"

20.5"

5.4"

4.5"

25.9"

Mounting Hole