Operation Manual

Table Of Contents

Preparation for Operation:

1. Install the side brushes and install the battery according to the manual.

2. Turn on the power switch on the side of the unit, and charge the battery for 4~6 hours

prior to the first operation.

3. To ensure the best efficiency of the unit, first is to remove clothes, paper, cable,

extension cable scattered on the floor, roll up the curtains and drapes if any to avert

the possible accident. In case of the cable entangled with the cleaner, the cable

could move around as the cleaner is working and might topple down the table,

chairs, even cabinet or cupboard.

※When start the unit.

→Check:

. Dust bin is full.

. Intake Valve is stuck with dirt.

.Wipe out the inner and outside of Intake Valve area.

Room containment of M680GMA may contain the cleaning area by

putting it in a proper place.

For example:

To contain the Robot Cleaner cleaning area A (shaded area) and not crossing to area B

by putting the Room containment in the position as shown in Fig. 3. And to contain area

B (shaded area) by putting the Room Containment in the position as shown in Fig. 4.

1. Operation without connecting to the docking station:

Place the cleaner on the floor and turn on the power switch then press the operation

button to operate, press again to stop.

2. When battery low, the unit is programmed to find the docking station automatically

for recharge. If the unit is failed to return to the docking station, user can put it back

connecting to the docking station manually.

3. Press the “ ” key from APP or press robotic control panel power button

to start clean.

GENERAL OPERATION

Fig. 3

Fig. 4