Installation Instructions

28
Problem
SolutionPossible Cause
1
2
Turn on the power
switch with no LED
display shown.
Vacuum on but can not
collect dirt or hair.
1. Battery is not installed
correctly.
2. Very low battery.
1. The dustbin is full.
2. The filter is not installed
correctly.
1. Install the battery
according to the manual.
2. Charge the battery
according to the manual.
1. Clean the dustbin.
2. Re-install the filter
correctly.
7
*** If the solution can not solve the problem, please contact to you local
dealer for service. ***
TROUBLE SHOOTING
The side brush be-
comes crooked, not
good to sweep.
Being used for a long time.
If it becomes crooked, you
could soak it in hot water to
have it recover to its original
shape.
3
Unit circles around
only.
One of the wires of the
wheels is loosened.
Open the wheel cover and
connect the loosened wire of
the wheel set properly or
contact your local dealer for
service.
4
Cannot start the unit.
1. The battery is not
installed properly.
2. Battery power is low.
3. The dust bin is not
installed properly.
1. To install the battery
properly, please refer to
page 13 for battery
installation.
2. Have the battery fully
charged.
3. Place back the dust bin
and turn it on again.
5
Unit could not
vacuum effectively
when it is turned on.
The LED display shows
error.
The dust bin filter is not
properly installed.
E1, E2, E3, E4, E5, E6, E7
and Beep 3 times.
Install the dust bin filter
properly.
Please refer to table A on
page 21 for solving the
problems.
6