Owner Manual

23
Schedule Work
1. Set the schedule according to the manual of Docking Station Control Panel.
(Please refer to page 21.)
2. The unit will work according to the schedule set.
Stop Operation
To stop the operation of the unit immediately: (1) turn off the power switch
on the right of the unit, or (2) press the “ ” key on the unit control panel
for more than 0.5 seconds, or (3) lift the unit off the floor and the unit will
stop 1 second later.
Unit Stoppage
1. The unit will stop after 1 second after being lifted up from the floor.
2. The unit will stop when the wheels are jammed for more than 20~30
seconds.
Other Function
If LOOP is not visible nearby:
Clap loudly 3 times and LOOP will Beep 3 times in response. If no beep
response, please walk around and clap again until the beep sound response
is heard.
Sleep Mode
When the unit is stopped and no key is pressed within 3 minutes, it will enter
sleep mode. Press ( ) or ( ) to activate unit from sleep mode.
To activate low power mode (sleep mode), put your robot on the docking
station with the power switch in the off (O) position. Turn the power switch
from off to on (I) six times consecutively, leaving the robot in the on (I)
position. The robot will not function while in sleep mode. To turn sleep mode
off, turn the power switch off and then back on.
By Remote Control
1. Press “Stop” button to start or stop cleaning.
2. Other functions please refer to the table listed on page 20.
GENERAL OPERATION