Owner Manual

16
Testing the Docking Station
Testing by Remote Control
Turn on the power on LOOP. Press the “find docking station” button “ ” to
activate the unit into docking mode. The unit will return to the docking station and
begin charging (please refer to page 15).
Testing by Unit
Press and hold the “ ” for 3 seconds, this will activate docking mode and the
unit will return to the docking station. The LED power indicator “ ” will turn red.
If the unit does not go back to the docking station and charge successfully, please
adjust the docking station to the proper height.
3. When charging, the LED indicator below the “ ” (Power) on LOOP will flash
green. When fully charged, the LED power indicator will stay solid green. It
will take 4~5 hours for the battery to fully charge.
4. If the LED indicator below the “ “ (Power) flashes RED, it means the power
switch is NOT turned on.
5. When battery is low, the LED power indicator “ ” (Power) will stay solid
RED.
Note: Please turn on the power switch when charging.
INSTALLATION GUIDE