Owner Manual

15
1. Before charging, please check if the battery is properly mounted and turn on
the switch. The power switch must be turned on to charge.
2. Two ways to charge the battery:
A. One way is to connect the charger adapter directly to LOOP. Insert the
adapter’s plug into the D.C. Jack on the side of the unit, then connect the
A.C. end of the adapter to a power outlet. Please connect the adapter to
the unit first before connecting to a power outlet.
B. The second way is by using the docking station that is included. Make
sure the docking station is placed evenly on hard surface as shown in
figure below. Connect the contact points on the back of the unit with the
contact plate on the docking station.
Recharging Battery
24V
O N
O FF
Adapter Plug D.C. Jack
Open Space
Turn Power Switch On
Use to Select
(Refer to page 19)
50 cm
50 c
m
24V
O N
O FF
100 cm
INSTALLATION GUIDE