User manual

5-18 Vertigo XG Configuration Guide
Dashboard - Vertigo XG’s Local Configuration Software
Device settings buttons
When Dashboard is in ADVANCED Settings Mode, selecting the tabs exposes the device’s
configuration pages, which allows you to edit the device’s current settings. Once you have
made the desired changes to the settings, you must apply the changes to the device by
selecting the A
PPLY CHANGES button. Note that for some changes to take effect, Dashboard
will request that the device be restarted (see R
ESTART DEVICE on page 5-6).
Figure 5-7. Device Settings buttons
You can retract the changes that you make to the device settings by performing an U
NDO,
as long as you haven’t already applied the changes. If you have made unwanted changes,
you can revert to the device’s default settings by pressing the RESTORE FACTORY DEFAULTS
button.
The following table summarizes the function of the three (3) buttons in the lower portion of
Dashboard’s device configuration pages.
R
ESTORE FACTORY
D
EFAULTS
Resets all of the parameter settings to Dashboard default settings.
A
PPLY CHANGES Applies all of the new settings from the page to the selected device.
U
NDO CHANGES Reinstates the page’s device settings back to what they were at the last
A
PPLY CHANGES action.
buttons
Device settings