User manual

2-2 Vertigo XG Configuration Guide
Overview of the Vertigo XG’s Hardware
The Vertigo XG’s front panel components
The Vertigo XG’s front panel features convenient access to the RAID10 hard drives, two
USB ports, a CD/DVD ROM drive, and a control panel containing six LEDs and three
buttons for system monitoring and operation. The table following the figure 2-1
describes
the function of each LED and button.
Figure 2-1. The Vertigo XG’s front panel components
S
YSTEM ALERT / POWER
F
AILURE
Indicates a power supply module has failed. This should be accompanied
by an audible alarm. A backup power supply module will take the load and
keep the system running, but the failed module will need to be replaced.
This red LED should be off when the system is operating normally.
O
VERHEAT / FAN FAIL When this red LED flashes, it indicates a fan failure. When it is constantly
illuminated (solid on), it indicates an overheat condition, which may be
caused by cables obstructing the airflow in the system or the ambient room
temperature being too warm. Check the routing of cables and make sure
that all fans are present and operating normally. You should also check to
make sure that the chassis covers are installed properly. Finally, verify that
the heatsinks are installed properly. This LED will remain flashing or on as
long as the above mentioned conditions exist.
LAN2 A flashing green LAN2 LED indicates network activity on LAN2.
POWER
USB 2.0
Connectors (2)
CD/DVD ROM Drive
RAID 10 Hard Drives
Floppy
Drive