User manual

5-36 Vertigo XG Configuration Guide
Dashboard - Vertigo XG’s Local Configuration Software
Hardware Settings > Audio page
The Audio page is a sub-page of the Hardware Settings tab, which is only visible when a
Vertigo hardware device is selected in the Dashboard’s device list. The Audio page (figure
5-16
) exposes parameters that allow you to set the Vertigo device’s audio processing.
Figure 5-16. The Audio page within Dashboard’s Hardware Settings
I
NPUT The Vertigo XG can be configured to capture only embedded audio, only
discrete audio, or a combination of both. Use the slider to select the
following settings:
• E
MBEDDED ONLY: Specifies that the audio input signal is embedded
in the video signal (SDI), rather than a discrete (AES) audio signal
(separate from the video signal).
•1 PAIR AES + 7 PAIRS EMBEDDED
•2 PAIRS AES + 6 PAIRS EMBEDDED
•3 PAIRS AES + 5 PAIRS EMBEDDED
•4 PAIRS AES + 4 PAIRS EMBEDDED
• AES ONLY: Specifies that the audio input signal is discrete (AES),
rather than being embedded (SDI) in the video signal.
• O
FFSET (FIELDS): Adds additional delay to the time it takes audio to be
captured at the input and then output again.