Operating instructions

2-16 Vertigo XG Installation & Quick Start Guide
Installation and quick start instructions
Assigning a new IP address to the Vertigo XG device
Factory configured Vertigo XG units are shipped with a dynamic IP address. Using DHCP
is not recommend, so you must assign a new static IP Address to the Vertigo XG device.
To change the Vertigo XG’s current dynamic IP address to a static IP address:
1. In the Vertigo Command Shell, type ipconfig and take note of the current IP configuration.
2. Again in the Vertigo Command Shell, type control to open the M
ICROSOFT CONTROL PANEL.
3. In the Microsoft Control Panel’s address bar, type 127.0.0.1 and press R
ETURN.
The VERTIGO XG PORTAL’S log in page appears.
4. Type vertigo into the Password field and click the L
OG IN button.
The V
ERTIGO XG PORTAL web interface appears.
5. Select the SETUP>NETWORK SETUP command to display the NETWORK SETUP page.
6. Change the IP
ADDRESS, SUBNET MASK, and DEFAULT GATEWAY values by typing the
new values in the corresponding text box.
7. Click the A
PPLY button.
A window appears asking you to confirm that you want to change the IP Address.
8. Click OK to restart the Vertigo XG unit and apply the new IP Address.